This paper presents RF impedance analysis as a nondestructive indicator of interconnect failure mechanisms. Physical changes on a printed circuit board can be detected using the TDR reflection coefficient as a measure of RF impedance. The test circuit in this study consisted of an impedance-controlled circuit board, a surface mount low-pass filter, and two solder joints providing both mechanical and electrical connections between them. A cyclic mechanical load was applied to generate either solder pad separation failures or cracking of the solder joints. In the case of pad separation, the test results showed that the TDR reflection coefficient gradually decreased as the pad lifted off the circuit board, which was distinguishable from the TDR response due to solder joint cracking. These results are explained using a simple theoretical analysis of the effect of each failure mechanism on impedance. This demonstrates that RF impedance analysis provides for the determination of failure mechanisms as well as early detection of both pad separation and solder joint degradation. The detection sensitivity for solder joint cracking using this technique is also discussed.

Complete article is available to CALCE Consortium Members.

© IEEE. Personal use of this material is permitted. However, permission to reprint/republish this material for advertising or promotional purposes or for creating new collective works for resale or redistribution to servers or lists, or to reuse any copyrighted component of this work in other works must be obtained from the IEEE.