International Journal of Refrigeration Vol. 32 (2009) 478–486

Reliability Design and Case Study of a Refrigerator
Compressor Subjected to Repetitive Loads

Seong-woo Woo
SAMSUNG Electronics Co., Ltd.
272, Oseon-Dong
Gwangsan-Gu Gwangju-City 506-723, South Korea

Michael Pecht
CALCE Electronic Packaging Research Center,
University of Maryland
College Park, MD 20742

Dennis L. O’Neal
Texas A&M University
College Station, TX, 77843-3123


A newly designed crankshaft of a compressor for a side-by-side (SBS) refrigerator was studied. Using mass and energy conservation balances, a variety of compressor loads typically found in a refrigeration cycle were analyzed. The laboratory failure modes and mechanisms were compressor locking and crankshaft wear. These were similar to those of the failed samples in the field. Failure analysis, accelerated life testing (ALT), and corrective actions were used to identify the key reliability parameters. The design parameters of the crankshaft included the hole locations and the groove of the crankshaft used for oil lubrication, crankshaft hardness, and thrust washer interference. Based on the analysis and design changes, the B1 life of the new design is now over ten years with a yearly failure rate of 0.01 percent. A five step procedure is recommended for parts design.

Index Terms:Refrigeration system, Compression system, Reciprocating compressor, Design, Component, Parameter, Capacity reduction.

Complete article is available to CALCE Consortium Members.


[Home Page] [Articles Page]
Copyright © 2009 by CALCE and the University of Maryland, All Rights Reserved